The Everhot 120 Plus
Higher Heat-Output Model.
Features:
Extremely Versatile - Two cast-iron hotplates and four ovens, all independently controlled.
Approximately 1.2kW heat output to the room (when both sides are at 'normal' cooking temperature).
Electric consumption: 170kWh per week.
Do note though that there is a lot of scope to reduce this down by about 50% by turning down (or off) ovens (or hotplates) that aren't in use.
One-Piece or Two-Piece Options
Although the Everhot 120 Plus is very heavy it can be ordered as a 'one-piece' version. We need to check access to the property though - it is a little awkward (to say the least!) to get in.
(Above - one piece model)
If this isn't practical it can be ordered as the two-piece model (note the central brackets in the hand-rail on the front - it's essentially two 60 models next to each other with the door hinging arranged to make a symetrical design).
(Above - two piece model)
There is a stainless steel joint-covering strip on the top and a colour-matched strip on the front to cover the small gap (2-3mm) between the two sections of the two-piece models.
Both versions have two external control boxes.
(If you fit the deeper 100mm rear infill please bear in mind you'll need two [one for each section] and a longer top-plate jointing strip.)
Oven and Hot-plate Temperatures and Dimensions
Each side of the Everhot 120 Plus is like an Everhot 60 so in total you have two large dual-zone cast-iron hot plates, two ovens (maximum 250 C) with integral grill and two lower ovens (maximum 180 C).
There are also two control boxes (one for each side of the cooker) and you can use the ECO energy-saving mode separately for each side.
Hot Plate #1 (Under Left Lid):
Left side:
225mm wide x 355mm deep
Maximum: 350 degrees C
Heat-up time to 300C: 20-40mins
Right side:
175mm wide x 355mm deep
Maximum: 350 degrees C
Heat-up time to 300C: 20-40mins
Hot Plate #2 (Under Right Lid):
Left side:
225mm wide x 355mm deep
Maximum: 350 degrees C
Heat-up time to 300C: 20-40mins
Right side:
175mm wide x 355mm deep
Maximum: 350 degrees C
Heat-up time to 300C: 20-40mins
Top Oven #1 (Left)
Dimensions
W: 395mm
H: 290mm
D: 490mm
Maximum temperature
(Measured at top): 250 C
Heat-up to 200C: 120-150min
Grill
Full area 2.5kW grill with 30min countdown timer
Top Oven #2 (Right)
Dimensions
W: 395mm
H: 290mm
D: 490mm
Maximum temperature
(Measured at top): 250 C
Heat-up to 200C: 120-150min
Grill
Full area 2.5kW grill with 30min countdown timer
Bottom Oven #1 (Left)
Dimensions
W: 395mm
H: 290mm
D: 470mm
Maximum temperature
(Measured at top): 180 C
Heat-up to 120C: 60-90min
Bottom Oven #2 (Right)
Dimensions
W: 395mm
H: 290mm
D: 470mm
Maximum temperature
(Measured at top): 180 C
Heat-up to 120C: 60-90min
Control Boxes
The Everhot 120 Plus has two remote (wired) control boxes that need to be located next to the cooker.
They are 220mm wide, 157mm high and 145mm deep.
Each has two cables exiting the rear - a 25mm diameter flexible conduit that runs to the back of the cooker and a second (smaller) flexible cable with a plug-top on the end that goes to the power socket.
They can both be located next to each other, or one to each side of the cooker.
These can be either on the worktop or in a base unit to the side of the cooker. (Please note - it's not practical to mount the control on the wall or in a wall cupboard/unit.)
Power Requirement
All that's required are two 13amp power sockets (these must be two single sockets, NOT a double) to the side of the cooker (NOT BEHIND IT!) - there cables exiting the back of the cooker (2m long), with plug-tops to go to the sockets which are recommended to be no more than 1m from its side (right or left).
Why two single sockets?
Socket Position
-800px.gif)
Dimensions
(The 120 Plus and 120i, one-piece and two-piece all share the same dimensions.)
Weight
The Everhot 120 Plus weighs approximately 500kg.
